A better speaker for the Miyoo Mini and Miyoo Mini Plus! ~ no soldering required! 🌟
For the audiophiles and avid Miyoo travelers out there, these speakers produce a much higher range of volume than the original and with a much crisper sound, while minimizing away the tinny sounds of the stock speakers in both the original Miyoo Mini and Miyoo Mini Plus.
This is a fantastic and easy upgrade to your daily handheld gaming companion ~ and great for guys like me who work outside and need that higher volume! ;D
*I have had them in every one of my own systems, and those I've made for my family and friends. They are very well known in the modding community.
The installation process is as easy as lifting the metal legs slightly, for contact - then dropping the speaker into it's designated spot, where the original speaker sits. Think of it like one of your favorite LEGO® Bricks! :)
Truly a great addition for those looking for a crisper sound and with no soldering necessary. :D
*************************************
*A very important notation before buying!!!! 🌟🌟🌟
This product is great, and installation is very easy, but placement must be exact for the desired results! If you do not hear sound after application, it is almost certain to be a user error.
But if you truly are unable after my personal help, I will happily take care of you in every way - whether it be a replacement or a refund for the item at cost to me.
Please do not give a poor rating or claim a defective item before contacting me, and I will always provide you with my happy help!
A few of us sellers are listing these as a service to help others receive them quickly, we make very little to no profit after shipping and fees - and one of the most beloved members of the Miyoo Community was recently bullied out of selling them. Please be kind, always - because you are loved for it! ❤️
*************************************
Installation help:
*The speaker must sit exactly as shown in picture four of the above listing, with the metal legs in the top right and top left of the speaker's bed.
*As the speaker connects to the PCB via contact with the board itself, I recommend gently placing the speaker in the bed without pressing it in fully. Allow the placement of the PCB on top to adjust it into its proper, permanent place and make full contact.
*To ensure as well that the metal contact legs make contact - if need be, use your tweezers to lift them slightly.
*If no audio is produced after dropping your new speaker in, then contact isn't being made, and one last adjustment to ensure full contact should do the trick ;D
Happy gaming, Miyoo fam! And may your bit tunes and PS1 orchestral compositions carry your days to greater heights! 💛